Teraflex

Teraflex Coil Springs are perfectly engineered for your Gladiator JT. The design is focused on extensive rate tuning and dynamic balance between front and rear and side-to-side load bias to produce lift that delivers unsurpassed highway handling and off-road performance. These progressive dual-rate ..

The TeraFlex 4” Lift Suspension System w/ Eight (8) Adjustable Alpine Flexarms & Track Bar for the Jeep Wrangler JK 2-door offers the Ultimate Suspension components needed to lift your JK Wrangler 2 door and get your Jeep capable of experiencing the off Road excitement of overcoming those larger obs..

Improve the ride quality and stability of your Jeep Wrangler JL with the Teraflex Falcon SP2 2.1 Monotube Shocks. All SP2 shocks offer a Mode Adjust that lets you rotate the fully extended shaft clockwise for performance mode or counterclockwise for a soft mode when installing. Performance mode is d..

Save your Jeep Wrangler’s brake lines from getting pinched, broken, snapped, cut, or crushed with the Teraflex Front Brake Line Anchor Kit. This heavy-duty kit was designed to conveniently relocate both front brake lines and wheel speed sensor wiring. The Anchors bolt on using existing lower shock b..

This bracket is designed to allow the factory Rubicon air locker compressor to mount to the TeraFlex BellyUp skidplate. Will fit all Rubicon model TJ Wranglers and Unlimiteds...

Whether you are on the side of the road or out on the trails, the factory scissor jack just won't cut it when you get a flat in your lifted Jeep Wrangler JL. Installing the Teraflex Hi-Lift Jack Mount Bracket Kit allows you to carry a Hi-Lift jack everywhere you go in case of emergency. The mount us..

The TeraFlex Spare Tire Relocation Bracket for Jeep Wrangler JL allows you to utilize the factory spare tire mounting bracket with minor modifications when you are upgrading to larger tires. This mounting bracket kit raises the spare tire up 2” and out 1.35” which provides just enough clearance to m..

The TeraFlex Heavy-Duty Front Tera44 TF44 Axle Assembly with ARB Locker for JK Wrangler & Rubicon with 4-6" of lift is the perfect Replacement Axle Housing for replacing weakened, strained, or damaged front axles in JK Wrangler and Rubicon vehicles. This Tera44 TF44 Axle Assembly can also be used as..

TeraFlex SpeedBumps are an innovative composite bumpstop system designed for high-speed, high-performance JK Wrangler applications. The maintenance free, performance tuned microcellular polyurethane technology provides a simple installation with no further adjustment or tuning required for a lifetim..

The TeraFlex PRO LCG suspension system is designed for the aggressive off road enthusiast that wants the best suspension performance for both rock crawling and high speed performance. The PRO system allows the vehicle to tackle the toughest rock crawling trails of Moab, and speed on the dunes at Gla..

The TeraFlex PRO-LCG suspension system is designed for the aggressive off road enthusiast that wants the best suspension performance for both rock crawling and high speed performance. The PRO system allows the vehicle to tackle the toughest rock crawling trails of Moab, and speed on the dunes at Gla..

TeraFlex Quick Disconnects are the leader in the industry. Disconnects allow for more front wheel travel and articulation providing better traction. Featuring Spherical polyurethane bushings eliminate noise and avoid metal-to-metal wear and tear. The design combines silent function with ease of use...

Heavy duty tie rod ends that utilize a one-ton joint end, and are available in either a stock Jeep® taper or a large one-ton taper (standard Dana 60). The stock taper rod ends will fit Dana 30 knuckle holes. Right small Tie Rod end. Replacement Parts for TeraFlex High Steer Systems. Not designed for..

Installing the Teraflex High-Angle Rzeppa CV Rear Driveshaft on your Jeep Wrangler JK allows for greater angles than traditional U-joints. With a Rzeppa CV joint that requires less maintenance and produces less wear, the design is proven to last longer and handle more stress. Many options are availa..

Get 4 awesome stickers from this one sheet! This sticker sheet includes two TeraFlex logo & badge stickers (approximately 7.75" w x 2.75" h) and two bage stickers (approximately 2.5" w x 2.5" h). These stickers are made from 4mil vinyl with a permanent adhesive and silkscreened for superior durabili..

The TeraFlex Front Tera60 Unit Bearing Axle Housing Assembly with ARB Locker & 5x5 Bolt Pattern for JK Wrangler with 0-6" Lift is a direct bolt-on upgrade for JK Wrangler owners looking to replace weakened, strained, or damaged front axles in JK Wrangler and Unlimited vehicles. By integrating the dr..

The TeraFlex 2” Front & Rear Bump Stop Strike Pad Extension Kit will give you the extra extension of the factory bump stops on lifted Jeep Wrangler JL & Wrangler JL Unlimited models to absorb the force created during intense compression and suspension travel. Combine with Teraflex's JL or JL Unlimit..

The TeraFlex rear axle bracket upper driver FlexArm mount for Jeep® Wrangler TJ is precision laser cut from 3/16” steel and accurately formed to ensure proper positioning for correct suspension geometry. This mount is available in raw steel and is ready to be welded on and painted. Designed for Dana..

The TeraFlex TJ performance suspension system is one of the best options for improved performance at a very moderate price. This kit allows suspension alignment to be performed through 4 adjustable lower FlexArms, and maintains highway drivability. This kit is 100% bolt on for simple installation. T..

You can expect a noticeably improved ride quality both on and off-road with the Falcon SP2 3.1 Piggyback Shocks installed on your Jeep Gladiator JT. The piggyback design along with the 2.25" 6061-T6 aluminum body allows more oil and gas capacity which cools faster and prevents loss of performance. A..

This sleeve is specially made to fit the tapered stud from a tie rod end stud. These sleeves can be handy for steering conversions. The outside diameter is 0.75" and requires a 0.75" smooth hole. once in place and the tie rod is tightened the sleeve wedges into place creating a very tight fit...

This strap was designed to use as a winch point from a tree without damaging the tree. It has plenty of strength and flex to pull you out of those tough places while leaving mother nature intact. 3” x 7'...

Protect the 2.5-3.5" lift kit installed on your Jeep Gladiator JT with the Teraflex 2” Stroke SpeedBump & Progressive Bump Stop Kit. Eliminate the harsh jarring impacts from standard bump stops with the maintenance-free SpeedBump kit that installs with minor cutting in the factory locations. Self-lu..

The TeraFlex Heavy-Duty Front Tera44 T44 Axle Assembly with ARB Locker for JK Wrangler & Rubicon with 0-3" of lift is the perfect Replacement Axle Housing for replacing weakened, strained, or damaged front axles in JK Wrangler and Rubicon vehicles. This Tera44 Axle Assembly can also be used as a dir..