Hub Assemblies & Hardware

These replacement rear hubs for the AMC Model 20 two-piece rear axle are made with no internal splines. They are shipped to you smooth. During instillation onto the rear axle shaft the splines are cut into the hub by the splines already formed on the axle shaft...

For use with 5 bolt hold hub flange (not included)...

For use with 6 bolt hold hub assembly (not included)...

..

The Crown Automotive Dana 44 Rear Axle Hub is a direct replacement for the original style two-piece Jeep axles. This hub is held in place by the key which is tapped into place to secure the assembly. This design can cause failure if too much torque is applied. This hub requires studs, sold separatel..

..

Front wheel bearing oil seal for '76-86 CJ with 2.313" spindle diameter...

Includes Wheel Speed Sensor...

..

Lousy roads full of potholes or a rough trail up to the lake can put a lot of stress on a Jeeps suspension and steering. The Crown Automotive Front Hub & Knuckle Assembly for Compass and Patriot vehicles is a replacement for the cracked unit your mechanic found when you brought it in for a wobbly wh..

..

Replacement Hub / Wheel Bearing assembly complete with Sensor. Replaces OE part number 52109947AD...

..

..

Front hub assembly for 1945-64 Jeep with 9" brakes, does not include studs...

..

A bad hub or bearing in your Jeeps front axle can lead to more costly repairs if not addressed properly. The Crown Automotive Front Hub Assembly is made for both left and right sides of the CJ Dana 30 axle. With a new hub installed you will notice smoother travelling, increased fuel economy and long..

Whether you have stripped and broken axle splines, sand-filled or water-logged bearings, these ready-built replacement hubs are the cure. Hub, bearings and seals are all pre-assembled and pre-lubricated for installation.Fits Late Year '99 w/ One Piece Cast Rotors See part 52417.04 for early to mid..

..

..

..

Each assembly requires 2 1 5/8" bearings. (Bearing sold seperately)..

..

..