Brand: Crown Automotive
Model: 56112-0905
Power Steering Applications Only...
27.30 USD
Ex Tax:27.30 USD
Brand: Crown Automotive
Model: 52417-05
- Type: Front Axle Hub Assemblies
Whether you have stripped and broken axle splines, sand-filled or water-logged bearings, these ready-built replacement hubs are the cure. Hub, bearings and seals are all pre-assembled and pre-lubricated for installation.Fits Late Year '99 w/ One Piece Cast Rotors
See part 52417.04 for early to mid..
131.30 USD
Ex Tax:131.30 USD
Brand: Crown Automotive
Model: 56009-0004
- Type: U-Bolts & Nuts
The Crown Automotive Front Leaf Spring U-Bolt is used on Jeep CJ and Willy's Dana 25 and 27 axles. Three of these are required as well as #J0808988. If you are changing your leaf springs, don't fight with rusty threads and mangled hardware, get fresh u-bolts from Crown, guaranteed to fit like the or..
6.81 USD
Ex Tax:6.81 USD
Brand: Crown Automotive
Model: 56113-02
- Type: Steering Shafts
One simple and straightforward way to optimize your Wrangler's performance is to replace its worn down, damaged, or malfunctioning steering shaft with Crown Automotive's OEM Lower Steering Shaft Assembly. Featuring a high-quality steering shaft, this assembly reduces play at the steering wheel to en..
161.20 USD
Ex Tax:161.20 USD
Brand: Crown Automotive
Model: 51309-97
- Type: Valve Cover Grommets
.45" with carbureted engine...
1.94 USD
Ex Tax:1.94 USD
Brand: Crown Automotive
Model: 52406-0047
The Crown Automotive Differential Bearing is for the Jeep CJ with the Dana 25 front axle. Pressed onto the differential carrier to keep the axle spinning with little resistance. Bad bearings suck the life out of the Jeeps power and can damage other critical components. This bearing requires cup #528..
91.00 USD
Ex Tax:91.00 USD
Brand: Crown Automotive
Model: 56119-0018
- Type: Steering Linkage Adjusters
..
22.10 USD
Ex Tax:22.10 USD
Brand: Crown Automotive
Model: 51406-0003
- Type: Exhaust Hangers & Insulators
..
1.94 USD
Ex Tax:1.94 USD
Brand: Crown Automotive
Model: 51001-0200
- Type: Valve Lifters
The valve lifters in older Jeep engines undergo some of the highest pressures inside the engine as they ride on the camshaft and activate the push rods to open the valves. If they start to wear at the spot where they make contact with the camshaft, it can throw off the engines performance and power...
15.60 USD
Ex Tax:15.60 USD
Brand: Crown Automotive
Model: 56015-1380
- Type: Front Bump Stops
The Crown Automotive Front Bump Stop replaces the factory jounce bumper found in the coil springs at the front of your Wrangler JL or Gladiator JT. This sturdy replacement fits into the factory cup and needs no modifications to install in place. If your original axle stop is broken or missing from a..
9.74 USD
Ex Tax:9.74 USD
Brand: Crown Automotive
Model: 51215-2002
- Type: Coolant Temperature Sensors
..
48.10 USD
Ex Tax:48.10 USD
Brand: Crown Automotive
Model: 52004-02
- Type: Clutch Slave Cylinders & Control Units
Fits the following applications:
87-89 Wrangler YJ with Peugeot BA 10/5 Manual Transmission91-92 Wrangler YJ with 4.0L Engine87-89 Cherokee XJ with Peugeot BA 10/5 Manual Transmission91-92 Cherokee XJ with 4.0L Engine..
130.64 USD
Ex Tax:130.64 USD
























