Crown Automotive

The Crown Automotive Sunrider Bow Knuckle is for the JK Wrangler soft top hardware. Enjoying some quick sun opening up the Jeep "sunroof" can put stress on this joint. Too much fun and the hinge can break. An easy replacement for the original framework so you do not need to purchase entire assemblie..

..

..

Sometimes even the most well maintained components on your CJ can fail over time and the wheel bearings are no stranger to this. If you are getting a lot of noise from the front wheel, it may be time to service your bearings. The Crown Automotive Wheel Bearing Kit includes the inner and outer bearin..

Does Not Include Bulb...

..

..

..

For restoration purposes this distributor has been crafted to look like the original, but on the inside it's a whole new story. The troublesome points have been replaced with a state of the art electro-magnetic pickup and a built-in electronic control module. With the hookup of the two simple wires ..

..

Do you find yourself arriving in your Jeep at your destination at night and wishing you could mark your presence or light someone's path to the car? If your front parking lamps are cloudy, dim, or unreliable, get yourself the Crown Automotive Front Parking Lamp. These lamps are easy to install on yo..

If you are overhauling your Jeeps transfer case, use original replacement parts like Crown Automotive Transfer Case Range Fork. Located on the range rail, these forks have been known to crack or split which can impact your shifting into or out of four-wheel-drive gears. New pads are required for sof..

The Crown Automotive Windshield Washer Reservoir is for the Wrangler TJ with a factory soft top. This reservoir has provisions for a single pump system used for the front windshield only and would not be able to be modified to work on hardtop models with rear wipers. This original replacement bottle..

..

..

Fits Left or Right Side Rear Body Mounts Under Cargo Area 1987-1995 YJ - Rear Lower Body Mounts; 4 required 1997-2006 TJ - Grille and Rear Lower Body Mounts; 5 required..

..

..

..

..

..

Handle Pull in Cinder for 82-95 Jeep CJ-7, CJ-8 Scrambler & Wrangler YJ. Sold Each...

..

..