Crown Automotive

The Crown Automotive M8 Hex Bolt is a direct replacement hardware component for Jeep vehicles. This bolt measures 30mm long and includes a captured washer to make installation easy...

The Crown Automotive replacement Passenger Side Drag Link End is ready to install on your TJ Wranglers factory steering linkage. This OE style drag link end has a greasable tie rod joint and connection points for the main tie rod and steering stabilizer. No brackets necessary, this is a direct fit p..

This sensor sends a signal to the engine management computer determining the location of the crankshaft in its rotation and signaling the firing sequence of the engine...

1953-71 CJ3B CJ5 CJ6 134 F-head 4 Cylinder-SOLEX DESIGN..

..

Rebuilding an Jeep axle is simple with Crown Automotive parts. This Inner Pinion Bearing Cup is a direct replacement for Dana axles, located inside the differential on the pinion shaft. This cup can be used with original bearing or replacement bearing, available separately...

..

..

Fits either right or left side...

..

..

..

..

Replacement power steering pressure hose...

12" Pigtail, before Catalytic converter..

..

..

..

When time or terrain has brought your Jeep's ball-joints to their end, replace and upgrade at the same time with Crown Automotive RT Heavy Duty Zero Lash Ball Joint Kit. These greasable joints are manufactured using sintered steel for the bushings which retain as much strength as possible by avoidin..

..

Replace your worn out starter with the Crown Starter Motor for your Jeep Wrangler TJ, YJ, Cherokee XJ and Grand Cherokee ZJ with a 4.0L engine. Crown offers a quality replacement that will allow your engine to turn over for many more years. This replacement includes a new solenoid to properly contro..

This bearing kit fits the Main drive gear for the 82-86 T4 & T5 transmission, and also works as the Bearing Kit for the rear Model 20 axle in 76-86 CJ's...

Replace your leaking and rusted factory exhaust with these complete exhaust kit from Crown Automotive. The kit comes with all pipes, gaskets and clamps to enable the replacement of the exhaust system. Kit does not include air tubes...

29-1/4" In Length.Not Compatible with Quadra-Trac Applications...